Step 2 · Filtration
Indoor air quality starts where your air comes from. We find what's getting in, fix it at the source, and build the plan from the readings.
Source control first
Whenever your system runs, the air in your rooms cycles through ducts that sit in a 130 to 150° attic. If attic air, dust and insulation fibers are getting into that loop, no filter in the house can keep up with it.
Free Duct & Attic Assessment, about 2 hours, with you present. We do not sell or service HVAC equipment.
Sound Familiar?
Dust is the visible symptom. Every one of these points at an opening between the attic, the garage and the loop your air travels in.
Takes about 15 seconds. Nothing is submitted.
Follow the Air
Six openings into the loop, plus the garage. Tap one to seal it and watch the load in the air drop. Most homes have several.
Behind the filter, nothing is filtered. A return-side gap no wider than a pencil, under blower suction for hours a day, keeps feeding attic air to every room. That is why we test the return side first.
Why the Order Matters
The same loop, one step at a time. Each step only works on the air the step before it left behind, so the order is fixed even when the list of steps isn’t.
The filter cleans the air at the grille. Then the return leak adds attic air after the filter, on every cycle. The house stays dusty, the filter loads up fast, and the purchase feels like it did nothing.
The leak is sealed first. Now every bit of air that moves through the loop passes the filter, and each pass takes more out than the house puts in. The same filter, doing the job it was bought for.
Not every home needs every step. Many homes are done after source control and the right filter. If the readings after the fix say you’re there, we tell you that, and we stop. Load bars are illustrative; your home’s readings come from the assessment.
Steps 2, 3 and 4
What each step adds once the loop is closed, and what none of them can do. Tools, not a package.
Step 2 · Filtration
Step 3 · Treatment
Step 4 · Dilution
How we decide
The assessment takes air quality readings along with the leakage test, room pressures, thermal images and photos. Source control is always first. Then the readings after the fix decide the rest: if the air tests clean with the right filter in place, that is the recommendation. Treatment is added when the circulating air still needs it; fresh air when the house itself is the remaining source.
Checked before any of them
Step 1 · Source Control, Ranked
Same goal, three methods. Which one fits depends on your ducts. Most homes with attic-air symptoms need the ducts and the ceiling addressed.
Which Concern Is This For
Source control, then filtration, treatment and fresh air, only when the readings call for them.
Backed By
Duct leakage and air quality readings are taken in every assessment, before anything is recommended. The sealing work can carry the Energy Savings guarantee, chosen with a target you set, plus the 20-year labor workmanship warranty on every job.
Measured first
If the readings say the filter is enough, we say so. If they say more is needed, you see the numbers that say so.
Energy Savings Guarantee
“Your system uses less energy after our improvements, by the amount you choose.”
Also on every job
Separate from the guarantees, which are about the result.
Questions
Proudly Local
From Buckeye to Maricopa, and the communities below.
Not sure whether we serve your home? Call (602) 675-6827 and we’ll be happy to assist.
Free Duct & Attic Assessment
About 2 hours, with you present. Leakage split by supply and return, room pressures, thermal images, air quality readings, with photos of every opening we find. If the loop tests tight, we say so.
Knights of the Attic does not sell or service HVAC equipment. Filtration, air purification and fresh air ventilation are part of the delivery system we work on: the ducts, the attic, and the air that moves between them.